You have 0 items in your cart.
Accessories
Sub Categories
Category:
O-Rings
One Set of Replacement O-Rings for PRTrans1000 Series (not available for Intrinsically Safe products).
Category:
Mounting Kits
The WaterBox101A is a weatherproof enclosure designed for use with MadgeTech’s 101A series data loggers. The enclosure provides a water tight seal, allowing non-water resistant data loggers to be used in wet environments. The WaterBox101A is machined out of black anodized aluminum, and has four oval mounting holes for easy surface attachment. The enclosure features a water-tight communication access plug with chain attachment, stainless steel probe outlet and a clear plastic cover. To use, simply unscrew the 6 hex screws and insert the data logger. Loosen the compression fitting and thread the sensor lead wire through the fitting. Attach the probe to the data logger and insert and tighten the six screws again, and it’s ready to use.
Category:
Data Logger Batteries
3.6 Volt, Lithium Battery, 750 mAH (pack of 14). Note: These batteries are only equipped with two leads and the leads have been cut for use with MadgeTech data loggers.
Category:
Interface Cables
Interface cable package for the TransiTemp and Cryo-Temp Series Data Loggers. Includes MadgeTech Software CD, Software Manual, Quick Start Guide, USB cable and USB Docking Station.
Category:
Probes
The RFOT-HDA is a probe attachment for the RFOT data logger. The device is built for use with hot dogs, sausages, and other small meat products. To use, simply slide the RFOT-HDA over the RFOT probe, then mount in place using two set screws. Next, insert a meat product through the o-ring onto the probe. The RFOT-HDA will guide the product into place, ensuring that the probe is inserted into the center of the product. Internal temperature can then be logged and analyzed using the RFOT data logger. The RFOT-HDA is also available in a smaller version called the RFOT-HDA-SM, which can be used with the RFOT-SMP (2.5" probe) data logger.
Category:
Mounting Kits
The Waterbox110C is a water resistant enclosure designed for use with the 110 series data loggers. This enclosure provides a water tight seal, allowing non-water resistant data loggers to be used in wet environments. The Waterbox110C is machined out of black anodized aluminum, and is wall mountable. The enclosure features a water-tight communication access plug and cable gland outlet. To use, simply unscrew the 4 hex screws and insert the data logger. Loosen the compression fitting and thread the sensor lead wire through the fitting. Attach the probe to the data logger and insert, then tighten the six screws again and it’s ready to use.