GW Instek

Sub Categories

00
Stemming from the design and manufacture demands of electronic industries, GW Instek offers diverse...
31
In addition to provid complete electronic test and measurement instruments, GW Instek...
5
The GW Instek Basic Test & Measurement instruments can be divided into 4 groups: Digital...
  • Filter

Features * 200/100/60 MHz Bandwidth * 2/4 Input Channels * 1GSa/s Real-Time and 25GSa/s Equivalent-Time Sampling * Maximum 25k Points Record Length * Large 5.6-in TFT Color Display * USB Host/Device: USB Printer and USB Flash Drive Supported * Battery Operation (optional) * Color Printout

Features: *30MHz Direct Digital Synthesizer(DDS)technique *20mHz Frequency Resolution *±10ppm Frequency Accuracy *12 Bit, 5M Sample/S Arbitrary Waveforms *Internally Synthesized FM, AM and Phase Modulation (PSK) *Linear and Log Sweeps *Arbitrary Modulation *Standard Interface: RS-232C*GPIB Interface (SFG-830G)

Features: ※ 3 LCR Measurement Functions ※ 1% Basic Accuracy ※ Test Frequency 120Hz/1kHz and Equivalent Circuit depends on selected Measuring Function & Range ※ High Resolution: 0.1uH, 0.1pF and 1mΩ ※ Dissipation Factor Measurement ※ Zero Adjustment ※ Optional Accessory: TL-06 for SMD Type Component

Features: ※ AC 32 Amperes High Test Current ※ Measuring Resistance 0 ~ 0.6Ω ※ Continue and Normal Test Mode ※ 4 Wire Measurement ※ GO-NOGO Function ※ Test and Result Output Signal

Features: Frequency Range : 0.1Hz ~ 10MHz Waveforms : Sine, Triangle, Square, Ramp, TTL and CMOS Output External Voltage Controlled Frequency (VCF) Function Duty Cycle Control with Signal Inversion Capability Variable DC Offset Control Two-Step (-20dBx2) and Variable attenuator Built-In 6 Digit Counter with INT/EXT Function up to 150MHz/High Resolution LIN/LOG Sweep Mode

Features: ※ For Troubleshooting or Testing Logic Circuits ※ Directly Injects Signal into Logic Circuits without Removing Components ※ Sync Input for Producing Externally Synced Signals ※ Operating Voltage Range: 5 ~ 15VDC ※ Maximum Input Probe Voltage: ± 35VDC ※ Maximum Sync Input Voltage: ± 120V/30sec ※ Sync Input Impedance: 1MΩ ※ Pulse Repetition Rate: 0.5/400Hz ※ Output Current: Pulser Mode, 100mA Sink/Source ※ Square Wave, 5mA Sink/Source ※ Dimensions & Weight: 18(W)x210(H)x18(D)mm: Approx. 40g

Features: Single Output High Resolution : 10mV, 1mA OVP, OCP Protection (by Software) Memory Store and Recall 100 Sets Auto Step Running With Timer Setting Standard Interface : RS-232C

Features: ※ Built-in Withstanding/Insulation Tester ※ 500VA Test Capacity ※ Zero Turn on Operating Switch ※ Automatic NG Indicator of Alarm Lamp and Buzzer ※ Lower Set for NO-Contact Judge ※ Digital Cut-Off Current Set ※ Test on and Result Output Signal ※ Auto W-I and I-W Test Procedure※ Optional : Remote Control Box GHT-106R